Statistiche
8 Domande
0 Risposte
RANK
35.107
of 290.037
REPUTAZIONE
1
CONTRIBUTI
8 Domande
0 Risposte
ACCETTAZIONE DELLE RISPOSTE
50.0%
VOTI RICEVUTI
0
RANK
of 144.430
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Domanda
nco output multiplied with digitised data in SIMULINK
When i multiplied the output of NCO with a digitised signal in SIMULINK, the output frequency spectrum shows only the influence ...
oltre 9 anni fa | 0 risposte | 0
0
risposteDomanda
maximum frequency output we get from NCO in SIMULINK
What is the maximum frequency output we get from NCO in SIMULINK?When i set the sample time in NCO to (1/10^6),it shows memory a...
oltre 9 anni fa | 0 risposte | 0
0
risposteDomanda
Simulink operations became slow
Hi, My simulink suddenly became very slow.Earlier simulink operations used to work very quickly.i have not done anything differ...
oltre 9 anni fa | 3 risposte | 0
3
risposteDomanda
OBSERVING SIGNAL GENERATOR OUTPUT AT HIGH FREQUENCY IN SIMULINK
Hi, In simulink,when i use signal generator at low frequency(egs:1 rad/sec) and observe the sine wave in a scope,my output is ...
oltre 9 anni fa | 1 risposta | 0
1
rispostaDomanda
how to observe the output of digital filter?
Hi, I am new to simulink.Inorder to observe the output of digital filter(lowpass) ,to what sink should i connect my filter.i tri...
oltre 9 anni fa | 1 risposta | 0
1
rispostaDomanda
to what sink should i connect to observe the output of digital filter.
Hi, I am new to simulink.Inorder to observe the output of digital filter(lowpass) ,to what sink should i connect my filter.i tr...
oltre 9 anni fa | 0 risposte | 0
0
risposteDomanda
About increasing the output duration of a signal generator
Hi, I am new to simulink.when i observe the signal genrator output in a scope ,i see that the signal appears only for 10 units....
oltre 9 anni fa | 1 risposta | 0
1
rispostaDomanda
how to observe digital outputs in simulink?
hi, i am new to simulink.how can i observe the output of lowpass filter in this example.To view analog signals we can use scope...
oltre 9 anni fa | 1 risposta | 0