You can get the IP address of the BeagleBoard hardware by listening to the audio output, or by using the Linux® command line. This is an optional task that you can use to:
Preparing a model to run on a board that is different from the previous one you used.
Opening a telnet session with a board whose IP settings you do not know.
Configuring the UDP Send block.
When you prepare a model to run on a board, your model Configuration Parameters reuse the IP settings of the previous board you used. If you are working with a different board on the same network, get the IP address of the your new board, and update the Host name parameter in the Configuration Parameters. For more information, see Run Model on BeagleBoard Hardware.
If Ethernet port on the BeagleBoard hardware board has an IP address, the audio output on the board can read the IP address out loud. For example the board can say "My IP address is one hundred and forty four point two one two point one one zero point two zero six."
To listen your board's IP address using headphones or speakers:
Plug headphones or speakers into the AUDIO OUT jack on the board.
Press the USER button on the board.
Write down the IP address as the board reads it out over the headphones or speakers.
The Linux command line on the board can provide the IP address of the Ethernet port.
To get your board's IP address command line session:
Open a serial command line session on your board, as described in Connect to Serial Port on BeagleBoard Hardware.
If your board is connected to a monitor, keyboard, and mouse, you can also log in to the Ubuntu™ desktop and open a terminal window.
At the Linux command line, enter ifconfig.
Locate the IP address following inet addr in the command line output. For example, locate inet addr:220.127.116.11 on line 9 of the following output:
omap login: ubuntu Password: Last login: Wed Nov 23 15:40:36 EST 2011 from ah-rdlugyhe1.dhcp.mathworks.com on pts/1 Welcome to Ubuntu 11.04 (GNU/Linux 3.0.4-x3 armv7l) * Documentation: https://help.ubuntu.com/ ubuntu@omap:~$ ifconfig eth0 Link encap:Ethernet HWaddr d2:a7:db:b3:c4:81 inet addr:18.104.22.168 Bcast:22.214.171.124 Mask:255.255.255.0 inet6 addr: fe80::d0a7:dbff:feb3:c481/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1488 Metric:1 RX packets:125537 errors:0 dropped:0 overruns:0 frame:0 TX packets:76 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:18103491 (18.1 MB) TX bytes:7670 (7.6 KB) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:4 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:240 (240.0 B) TX bytes:240 (240.0 B) ubuntu@omap:~$