Send UDP messages to remote interface
Configure the TCP/IP stack to send UDP messages to a remote interface.
Use this block when the transmission speed is of higher priority than reliability or the order of messages.
The Arduino Ethernet shield uses the following pins on different variants of Arduino boards.
If you set the Target hardware parameter to:
Arduino Mega 2560, pin numbers from 50 to 53 are used.
Arduino Uno, pin numbers from 10 to 13 are used.
You cannot use this block for Arduino Nano target hardware.
If you run a simulation of a model that contains this block without the target hardware, this block outputs zeroes. See Block Produces Zeros or Does Nothing in Simulation
Enter the IP address of the remote interface to send UDP messages.
Enter the remote port of the remote interface to send UDP messages. The remote IP port numbers range from 0 to 65535.
Enter the local port number from which you want send the UDP messages to the remote interface. The local IP port numbers range from 0 to 65535.